To clean this large equipment, the first thing to do is to dismantle the equipment and ensure that the structure inside is well cleaned. Due to the clean appearance of the equipment, it is basically useless. The reason we clean the equipment is to make it last longer. After all, this device is used to purify water.

After dismantling the equipment, it is necessary to use chemical reagents to stop the cleaning of the water gun. This powerful cleaning method can effectively remove internal scum. After cleaning with a water gun, it is necessary to stop washing again and rinse several times with clean water to clean the chemicals.

After cleaning the equipment parts, some mechanisms need to apply a little smooth engine oil to maintain the wear and tear of the equipment parts. Maintenance is required inside the equipment, otherwise problems may occur during the working process.

Fault analysis of ultra pure water equipment

Fault 1: The switch does not close or trips frequently

Fault analysis: It may be caused by switch aging, water pump blockage or circuit aging, short circuit, thin or missing wires.

Solution: Turn off the power first, then use an electricity meter to measure the motor and check if the three phases are short circuited or grounded. When measuring, please carefully remove the output terminals of the inverter to prevent the module from burning out. Rotate the motor by hand to check if it is stuck, and replace the switch if necessary.

Fault 2: The system cannot fetch water

Solution: First check if there is water in the pool and if the motor is running. If the motor rotates, the inverter of the ultra pure water equipment may also be redirected. Then remove the pump and inspect the welded impeller for damage. Check the one-way valve again. If the one-way valve is located in front of the motor and there is water in front of it, discharge the water from the motor.

Fault 3: Pressure too high when starting the pump

Solution: Check if the pipeline is blocked or leaking, which may cause sudden pressure changes or poor pressure maintenance. The flow rate of pipelines can also have an impact. The automatic decrease in flow rate will cause the pump to start, and the pressure from the outlet to the blockage will suddenly increase, resulting in incorrect pressure control actions and frequent leakage. The pump also starts. Now there is a water hammer.

专业水处理的疑难问题，产品选型问题，可以单击下面的微信二维码电话联系贺工在线指导，长按微信二维码可自动识别添加贺工微信沟通解决您的疑难问题