The equipment we use in our daily lives may often encounter water, and if it does not have a good waterproof effect, it may cause damage to the equipment or even be reimbursed directly. So how do we do waterproof treatment for the equipment?

In equipment installation, waterproofing is an essential basic task in the early stages. Proper waterproofing and safety protection can effectively prevent common faults caused by water seepage, thereby increasing the service life of the equipment. If the equipment in the room does not comply with waterproofing regulations, it is strictly prohibited to install it in areas that are likely to be exposed to rain or very humid. If it is necessary to disassemble protective covers and other components during the entire process of equipment maintenance, try to ensure that the sealing ring is installed properly after the actual operation is completed.

Waterproofing treatment belongs to the concealed engineering of interior decoration, especially in the waterproofing work of bathrooms, restaurants, and kitchens. It is necessary for everyone to pay more attention to the construction of connection points with missing location details, and the waterproof building coating must be wiped in a timely manner. When pipelines, odor proof floor drains, etc. pass through the regenerated concrete floor slab, the waterproof layer near the cracks must be carefully constructed. All water and drainage pipes must be reinforced with concrete, and a 10-20cm waterproof building coating should be applied from the road surface. Then, a waterproof layer should be applied on the road surface to form a composite waterproof layer to improve the waterproof characteristics.

In order to better waterproof the equipment, sealing gaskets should be used, and additional sealing gaskets should be added to the screws. Generally, elastic materials should be used to achieve the waterproof effect. Due to the variety of equipment in the equipment compartment, dismantling and repairing it is difficult. Considering that the road surface waterproofing treatment is not carried out without dismantling the equipment, the first step is to clean the equipment compartment road surface, eliminate the gray layer and loose cement mortar reference surface of the road surface, and use a quick setting waterproof sealing material to carry out the reference surface repair.

When designing the overall outdoor equipment, waterproof characteristics were taken into consideration. However, in order to better prevent water leakage and increase the service life of the equipment, common problems during installation and maintenance are as follows: 1. The tail line has the function of a sealed design scheme and cannot be disassembled or broken casually. Randomly disassembling and breaking the tail wire is likely to cause a short circuit fault in the route, resulting in abnormal operation of the equipment. 2. After connecting the tail wires of the equipment, please try to use waterproof tape to waterproof the tail wires and ensure the sealing of all tail wire sockets. 3. When customers choose L-shaped poles for installation, it is strongly recommended that the horizontal bars have a certain upward angle to avoid backflow of precipitation to the top of the ball machine due to poor sealing of the horizontal bars.

The key to the quality of waterproofing construction lies in the treatment of connection points in waterproofing details, which is both the key and difficult point of waterproofing. After the waterproof layer meets the standard for water sealing, the surface of the waterproof coating that has been repaired and left by humans should be covered with floor glue for maintenance. Other non moving positions may not have a protective layer set, and the total width of the protective layer should be 500mm.

专业水处理的疑难问题，产品选型问题，可以单击下面的微信二维码电话联系贺工在线指导，长按微信二维码可自动识别添加贺工微信沟通解决您的疑难问题