What is activated carbon? If you have heard of cases of using charcoal to obtain drinking water, you know that charcoal can filter out a lot of impurities, and ordinary sewage can be directly used for drinking if treated properly. So how to replace the activated carbon of pure water equipment?

1. Special tools are required for dismantling and replacing activated carbon: pipe pliers, sand suction tubes, and raw tape.

Before replacing activated carbon, it is necessary to conduct a comprehensive inspection of the machine equipment to see if there are any damaged parts that have not been detected. If there are any, it should be immediately reported to the customer and the main operating parameters should be recorded, especially the leakage working pressure of activated carbon.

3. To shut down the pure water equipment, first stop the RO reverse osmosis server pump, then stop the original centrifugal water pump, and then turn off the leakage of the original centrifugal water pump.

4. When replacing sand and charcoal, it is usually done first. As the newly installed activated charcoal needs to be soaked in tap water to make it sufficiently wet, remove the gas between the charcoal particles and the internal gaps, and prevent the charcoal particles from floating on the sea, all in order to save time. First, place a small amount of water at the bottom of the charcoal filter, and then fill it with activated carbon.

The filling volume of activated carbon in pure water equipment is about 6% of the total volume of the carbon filter tank. Facilitate the retention of sufficient indoor space for softeners. After installing the charcoal, water leaks into the charcoal canister, allowing the water to completely soak the activated carbon.

6. Before replacement, a small amount of water should also be introduced into the sand tank, and filled in the order of large sand at the bottom and small sand at the top. The filling volume is about 80% of the sand tank.

7. After filling, reinstall the pure water equipment. Washable, before washing, it is necessary to ensure that the gate valve is properly opened, including the water valve and drain valve, and close the water valve of the activated carbon. Subsequently, open the original centrifugal water pump, wash first, and then proceed to the softener. Subsequently, the front and back washing were carried out alternately. Until the water from the sewage valve responds as.

8. Confirm that it has been cleaned thoroughly, use the original centrifugal water pump to clean the activated carbon, wash it first and then soften it. After washing until the water output is completely transparent without color or ultrafine particles, it can be delivered for use. When cleaning activated carbon, turn off the water leakage of the softener.

专业水处理的疑难问题，产品选型问题，可以单击下面的微信二维码电话联系贺工在线指导，长按微信二维码可自动识别添加贺工微信沟通解决您的疑难问题