There is a crucial component in water treatment equipment, which is the compressor. Its function is to release steam and achieve high pressure. How to install this type of equipment well?

The installation of water treatment equipment, air conditioning and ventilation equipment is aimed at the refrigeration working principle of most coolers. The function of the compressor is to convert steam with lower working pressure into steam with higher working pressure, reducing the volume of steam and increasing the working pressure. The compressor is responsible for absorbing, shrinking, and transporting refrigerant vapor. A cooler is a mechanical device that releases heat and transfers the heat absorbed by the evaporator of an air conditioner, along with the heat converted by the compressor, to the refrigerant. Cleaning steps for central air conditioning ducts: Firstly, master the reasonable layout of the software for the fresh air system ducts, return ventilation ducts, and exhaust ducts based on the engineering drawings. 2、 Using ventilation duct system software for enterprise cleaning, disinfection, and sterilization.

Drill holes in the selected area or fix the purified water equipment in place. The hole should be round, deep and precise in position, and there should be no cracks, gaps, or burrs around the hole. Connect to the tap water pipeline. First, turn off the main drinking water gate, connect the purified water equipment, and wrap the plug with adhesive tape to prevent water leakage.

The common problem is that the compressor suddenly shuts down during operation, and the reasons for the sudden shutdown include: the breathing working pressure is too low, which is less than the bottom pressure limit value of the pressure controller; The working pressure of the exhaust pipe is too high, causing the high-pressure relay to shut off the power supply in a posture; Low vapor pressure, vapor pressure car relay posture relay; Motor load, thermal relay posture relay.

The water treatment equipment can immediately put the sewage pipe into the sewage pipeline, and the port number should be left with a certain indoor space to prevent wastewater from flowing back into the direct drinking water equipment and avoid the "siphon" condition of the sewage outlet. If the sewage pipe of the direct drinking water equipment is immediately put into the sewage pipeline, a gate valve should be installed at the end of the sewage pipe, which can be opened irregularly to have sewage treatment effect. The sewage pipe can also be immediately connected to the original drinking water faucet. The sewage pipe and the sewage outlet of the purified water equipment must be properly connected to prevent water seepage.

The reasons for the noise in the compressor motor coupling are: poor coordination between the compressor and motor coupling; The key and groove of the coupling device do not match well with each other; Loose or damaged extensibility ring of the coupling device; The transmission belt is too loose; The internal thread of the coupling is loose from the fit of the shaft.

专业水处理的疑难问题，产品选型问题，可以单击下面的微信二维码电话联系贺工在线指导，长按微信二维码可自动识别添加贺工微信沟通解决您的疑难问题